Automatic Transmission Shift Lock Control - Assemble - Off Vehicle

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2001 Pontiac Firebird, 2001 Pontiac Bonneville, 2001 Chevrolet Monte Carlo, 2001 Chevrolet Impala, and 2001 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.

Install the automatic transmission shift lock control.
Put the column in the NEUTRAL position.

Fig 1: Shift Lock Control
Courtesy of GENERAL MOTORS CORP.
Adjust the automatic transmission shift lock control by performing the following steps:
1. Pull the tab (1) out on the block side of the automatic transmission shift lock control.
2. Press on the adjuster block (2) to compress the internal adjuster spring to disengage the adjuster teeth. Slide the adjuster block as far away from the solenoid as possible.
3. Lock in place by pushing the tab back in.

Fig 2: Adjuster Block

Courtesy of GENERAL MOTORS CORP.

Inspect the automatic transmission shift lock control by performing the following steps:
1. The automatic transmission shift lock control must lock the gear shift lever when it is put into the PARK position.
2. When the column is installed in the vehicle you will not be able to shift the gear shift lever out of the PARK position without pressing on the brake pedal. The solenoid will be energized.
3. Readjust if needed.
Install the upper and lower trim covers. Refer to STEERING COLUMN TRIM COVERS - ASSEMBLE - OFF VEHICLE .
Enable the inflatable restraint steering wheel module. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .