LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Steering Wheel And Steering Column) >> Adjustments >> Dimmer Switch

Dimmer Switch

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2001 Pontiac Firebird, 2001 Pontiac Bonneville, 2001 Chevrolet Monte Carlo, 2001 Chevrolet Impala, and 2001 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
  1. With switch removed from column bracket, insert a 3/32" drill bit into adjusting pin hole to limit switch travel. See Fig 1. Insert actuator rod into switch. Install switch to column bracket, finger-tighten screws.
  2. Lightly push switch upward against actuator rod until no lash (free-play) exists between rod and switch. Tighten mounting screws to 35 INCH lbs. (4 N.m). Remove drill bit. Ensure proper switch operation using dimmer/headlight switch handle.
Fig 1: Adjusting Dimmer Switch
G92E04477Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals