LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Steering Wheel And Steering Column) >> Adjustments >> BTSI & Park Lock System >> Adjustment (Column Shift "E" & "K" Bodies)

Adjustment (Column Shift "E" & "K" Bodies)

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2001 Pontiac Firebird, 2001 Pontiac Bonneville, 2001 Chevrolet Monte Carlo, 2001 Chevrolet Impala, and 2001 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Lock cylinder must be in RUN position when park lock cable is removed from or inserted into ignition switch inhibitor.

Turn lock cylinder to RUN position, depress brake pedal. Move shift lever out of Park position. Disengage locking button, pull cable away from solenoid until fitting starts to extend, compressing spring inside ball joint. Allow cable to move back.04-.08" (1-2 mm), engage locking button. See Figure. Recheck BTSI system. If system does not operate as specified, repeat procedure.

scientia non olet · About LEMON Manuals