LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1297 (Wiring Systems (General Information)) >> Repair Instructions >> Accessory Power Receptacle Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the accessory power receptacle switch (5) to the bezel (3), by pushing in until the tabs lock in.
  2. Connect the electrical connector.
  3. Gently install the accessory power receptacle switch bezel (3) by pressing into place until the upper tabs (1) and lower tabs (4) are fully seated.
  4. Connect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE in Engine Electrical.
    Fig 1: Installing Accessory Power Receptacle Switch To Bezel
    G01435741Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals