LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1297 (Wiring Systems (General Information)) >> Repair Instructions >> Accessory Power Receptacle Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE in Engine Electrical.
  2. Using a flat bladed tool, disengage the 3 upper clips (1) and the 2 lower clips (4) on the accessory power receptacle bezel (3).
  3. Disconnect the electrical connector.
    Fig 1: Identifying Clips On Bezel
    G01435734Courtesy of GENERAL MOTORS CORP.
  4. Disengage the 2 clips (1) on the accessory power receptacle (2).
    Fig 2: Disengaging Clips On Accessory Power Receptacle
    G01435735Courtesy of GENERAL MOTORS CORP.
  5. Remove the accessory power receptacle (2) from the bezel (3).
    Fig 3: Removing Accessory Power Receptacle From Bezel
    G01435736Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals