Terminal Removal

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Follow the steps below in order to repair push to seat connectors.

Remove the terminal position assurance (TPA) device, the connector position assurance (CPA) device, and/or the secondary lock.
Separate the connector halves (1).

Fig 1: Separating Connector Halves
Courtesy of GENERAL MOTORS CORP.
Use the proper pick or removal tool (1) in order to release the terminal.

Fig 2: Releasing Terminal
Courtesy of GENERAL MOTORS CORP.
Gently pull the cable and the terminal (2) out of the back of the connector.
Re-form the locking device if you are going to reuse the terminal (1).

Fig 3: Reforming Locking Device
Courtesy of GENERAL MOTORS CORP.
To repair the terminal, refer to Terminal Repair.