LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1297 (Wiring Systems (General Information)) >> Diagnostic Information and Procedures >> Pull to Seat Connectors >> Terminal Removal

Terminal Removal

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Follow the steps below in order to repair pull-to-seat connectors.

  1. Remove the terminal position assurance (TPA) device, the connector position assurance (CPA) device, and/or the secondary lock.
  2. Separate the connector halves.
  3. Using the proper pick or removal tool insert into the front of the connector body.
  4. Grasp the wire at the back of the connector body and gently pull the terminal (1) from the connector body (3).
    Fig 1: Pulling Terminal From Connector Body
    G01435729Courtesy of GENERAL MOTORS CORP.
  5. Inspect the terminal for damage, if damaged refer to Terminal Repair.
  6. Reform the locking tang (2) if the terminal is being reused.
scientia non olet · About LEMON Manuals