LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1296 (Manual Transmission Clutches) >> Repair Instructions >> Clutch Start Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE .
  1. Install the clutch start switch and retaining nut.

    Tighten 

    Tighten the retaining nut to 16 N.m (12 lb ft).

  2. Connect the clutch start switch electrical connector.
  3. Check the clutch start switch for proper operation.
scientia non olet · About LEMON Manuals