LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1295 (Manual Transmission - MTN) >> Repair Instructions >> Transaxle Mount Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE .
  1. Install the front transaxle bracket and bolts.

    Tighten 

    Tighten the transaxle bracket bolts to 64 N.m (47 lb ft).

  2. Install the insulator to the mount bracket.
  3. Install the front transaxle mount through bolt.

    Tighten 

    Tighten the transaxle mount through bolt to 52 N.m (38 lb ft).

  4. Install the 2 bolts to the front transaxle mount.

    Tighten 

    Tighten the front transaxle mount bolts to 64 N.m (47 lb ft).

  5. Install the left hand and right hand splash shields.
  6. Lower the vehicle.
  7. Remove the engine support fixture.
scientia non olet · About LEMON Manuals