LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1294 (Manual Transmission - MK5) >> Repair Instructions >> Transaxle Mount Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE .
  1. Install the transaxle bracket and bolts on the transaxle.

    Tighten 

    Tighten the transaxle bracket bolts to 52 N.m (38 lb ft).

  2. Install the left transaxle mount and bolts to the body rail.

    Tighten 

    Tighten the left transaxle mount bolts to 52 N.m (38 lb ft).

  3. Install the transaxle mount through bolt.

    Tighten 

    Tighten the transaxle mount through bolt to 80 N.m (59 lb ft).

  4. Remove the engine support fixture from the engine.
  5. Install the air cleaner box.
  6. Install the air cleaner box bolts.
  7. Install the air filter.
  8. Install the air cleaner hose and cap assembly.
  9. Connect the MAF connector.
  10. Connect the hoses to the air cleaner case assembly.
  11. Install the battery tray and battery. Refer to BATTERY REPLACEMENT in Battery.
  12. Install the hold down bracket.
  13. Install the hold down bracket bolt and nut.

    Tighten 

    Tighten the hold down bracket bolt and nut to 12 N.m (106 lb in).

  14. Connect the positive and negative battery cables.
scientia non olet · About LEMON Manuals