LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1290 (Engine Mechanical - 1.8L (LV6)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Front Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to BATTERY DISCONNECT CAUTION .
  1. Disconnect the negative battery cable.
  2. Remove the crankshaft pulley. Refer to CRANKSHAFT PULLEY REPLACEMENT  .

    Important:  To protect the crankshaft from damage, wrap the tip of the screwdriver with tape.

  3. Use a screwdriver and pry out the crankshaft front oil seal.
    Fig 1: Removing Crankshaft Front Oil Seal
    G01546720Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals