Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Lubricate the new crankshaft front oil seal with Chassis Grease GM P/N 1051344 (Canadian P/N 993037) or equivalent.
- Using a hammer and an appropriate driver, lightly tap the crankshaft front oil seal into place.
Important: Tap the oil seal in until its surface is flush with the crankshaft front oil seal retainer edge.
- Install the crankshaft pulley. Refer to CRANKSHAFT PULLEY REPLACEMENT
.NOTE: Refer to FASTENER NOTICE .
- Connect the negative battery cable.
Tighten
Tighten the battery cable bolt to 15 N.m (11 lb ft).
- Start the engine.