LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1290 (Engine Mechanical - 1.8L (LV6)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Cylinder Head Removal

Cylinder Head Removal

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the following items in sequence:
    • The cylinder head bolts
    • The cylinder head washers
      Fig 1: Identifying Cylinder Head Bolts Removal Sequence
      G01546869Courtesy of GENERAL MOTORS CORP.
  2. Remove the cylinder head.
    Fig 2: Removing Cylinder Head
    G01546870Courtesy of GENERAL MOTORS CORP.
  3. Remove the cylinder head gasket (1).
    Fig 3: Removing Cylinder Head Gasket
    G01546871Courtesy of GENERAL MOTORS CORP.
  4. Clean the cylinder block mating surfaces.
    Fig 4: Cleaning Cylinder Block Mating Surfaces
    G01546872Courtesy of GENERAL MOTORS CORP.
  5. Clean the cylinder head mating surface.
    Fig 5: Cleaning Cylinder Head Mating Surface
    G01546873Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals