LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1285 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement (FWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the stabilizer shaft on the crossmember.
  2. Install the 2 stabilizer shaft insulators to the stabilizer shaft.
  3. Install the 2 clamps to the insulators.
    NOTE: Refer to FASTENER NOTICE .
  4. Install the 4 bolts to the clamps.

    Tighten 

    Tighten the bolts to 19 N.m (14.0 lb ft).

  5. Install the stabilizer shaft and the crossmember to the vehicle. Refer to FRONT SUSPENSION CROSSMEMBER REPLACEMENT (FWD)  or FRONT SUSPENSION CROSSMEMBER REPLACEMENT (AWD)  .
scientia non olet · About LEMON Manuals