LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1282 (Power Steering System) >> Repair Instructions >> Power Steering Reservoir Outlet Pipe/Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place a drain pan under the vehicle in order to catch any power steering fluid.
  2. Loosen the hose clamp (4) that retains the reservoir outlet hose to the power steering pump.
    NOTE: Refer to POWER STEERING HOSE DISCONNECTED NOTICE .
  3. Remove the reservoir outlet hose from the pump.
  4. Loosen the hose clamp (2) that retains the reservoir outlet hose to the power steering fluid reservoir.
  5. Remove the reservoir outlet hose from the reservoir.
Fig 1: Removing Reservoir Outlet Hose From Reservoir
G01545626Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals