LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1279 (Jacking And Lifting) >> Lifting And Jacking The Vehicle >> Floor Jacks >> Under Rear Suspension Crossmember

Under Rear Suspension Crossmember

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The floor jack (2) pad must not be placed under the rear suspension crossmember (3) front reinforcement rib.

Position the floor jack (2) pad as shown in the illustration.

Fig 1: Positioning Floor Jack Under Rear Suspension Crossmember
G02707466Courtesy of GENERAL MOTORS CORP.