Spark Plugs: Installation

WARNING: This page is about a different car, the 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: DO NOT coat spark plug threads with anti-seize compound. If anti-seize compound is used and spark plugs are over-torqued, damage to the cylinder head threads may result.

Gap the spark plugs to .045" (1.1 mm). Install the spark plugs. Tighten the spark plugs to specification. See TORQUE SPECIFICATIONS . Apply dielectric compound to spark plug boots and make sure no corrosion is present. Install ignition coil housing. See IGNITION COIL HOUSING .

New spark plugs are pre-gapped. If spark plug is dropped, it should be replaced. Gap the spark plugs to .035-.043" (0.9-1.0 mm). Install the spark plugs. Tighten the spark plugs to specification. See TORQUE SPECIFICATIONS . Install EI module. See ELECTRONIC IGNITION MODULE .