Removal (Knock Sensor 2 - 3.0L)
WARNING: This page is about a different car, the 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Turn steering wheel all the way to the right. Turn OFF the ignition. Remove knock sensor 2 harness connector. See Figure . Remove knock sensor 2 pigtail from camshaft position sensor clip.
- Pull sensor pigtail wire away from the one attachment clip located about 6" down the wire from the camshaft position sensor clip. Tie a 4 foot long string to one end of the knock sensor 2 connector and the other end to a fixed component near the camshaft position sensor.
- Raise and support vehicle. Remove knock sensor 2 attachment bolt and guide the knock sensor with string out from the bottom. Remove string from end of knock sensor, but leave string hanging.