LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Engine Controls - Removal, Overhaul & Installation) >> Ignition Systems >> Crankshaft Position Sensor >> Removal (2.2L)

Removal (2.2L)

WARNING: This page is about a different car, the 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Crankshaft Position (CKP) sensor is located in cylinder block, behind the starter motor. See Figure . Turn OFF the ignition. Record preset radio stations. Disconnect negative battery cable. Disconnect wiring at starter solenoid. Raise and support vehicle. Remove the two starter solenoid harness connector attachment nuts.
  2. Remove lower starter assembly-to-engine block bolt. Remove upper starter assembly-to-engine block bolt. Move starter right to clear engine block, then left to remove starter from flywheel housing. Disconnect CKP sensor harness connector. Remove CKP sensor attachment bolt and remove CKP sensor.
scientia non olet · About LEMON Manuals