LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Engine Controls - Removal, Overhaul & Installation) >> Emission Systems & Sub-Systems >> EVAP Purge Solenoid >> Installation

EVAP Purge Solenoid: Installation

WARNING: This page is about a different car, the 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install EVAP purge solenoid vacuum supply hose to EVAP purge solenoid. Install EVAP purge solenoid and line assembly into attachment grommet and V-clamp. Connect EVAP purge line quick-connect, then pull back on line to confirm locked engagement.
  2. Connect EVAP purge solenoid harness connector. Push in connector until a click is heard and pull back to confirm engagement. Install outlet resonator/duct assembly into position. Tighten clamp at throttle body assembly. Position outlet resonator/duct assembly to support bracket and install bolts.
  3. Tighten outlet resonator/duct assembly-to-support bracket bolts to specification. See TORQUE SPECIFICATIONS  . Tighten clamp at air cleaner assembly.
scientia non olet · About LEMON Manuals