LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1269 (Seat Belt System) >> Repair Instructions >> Bracket Replacement - Child Seat Belt Restraint System >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the bracket in the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Apply a thread sealant, GM P/N 12345382, Canadian P/N 10953489, Loctite 242, Permatex 24200 to the threads of the bolts (2) and also the stud for the bracket nut (1).
  3. Install the bolts (2) to each end of the bracket.

    Tighten 

    Tighten the child seat latch bracket bolts to 42 N.m (31 lb ft).

  4. Install the bracket nut (1) between the center seat belts.

    Tighten 

    Tighten the child seat latch bracket nut to 42 N.m (31 lb ft).

  5. Install the rear center seat belts. Refer to SEAT BELT REPLACEMENT - CENTER REAR  .
  6. Install the rear seat back. Refer toSEAT BACK REPLACEMENT - REAR (STATIONARY) or SEAT BACK REPLACEMENT - REAR (FOLDING) in Seats.
    Fig 1: Installation Procedure Child Seat Belt Restraint System Bracket
    G01504748Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals