LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1268 (Body Rear End) >> Repair Instructions >> Fuel Filler Pocket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fuel filler pocket to the quarter panel.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the screws to the fuel filler pocket.

    Tighten 

    Tighten the fuel filler pocket screws to 2 N.m (18 lb in).

  3. Install the bolts to the fuel filler pocket at the fuel filler neck.

    Tighten 

    Tighten the fuel filler pocket to fuel filler neck bolts to 5 N.m (44 lb in).

  4. Install the rear bumper fascia splash shield. Refer to WHEELHOUSE LINER PANEL REPLACEMENT - REAR  in Bumpers.
    Fig 1: Installing Fuel Filler Pocket To Quarter Panel
    G01504554Courtesy of GENERAL MOTORS CORP.
  5. Replace the fuel filler cap.
  6. Close the fuel filler door.
scientia non olet · About LEMON Manuals