Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

For power adjusters only, snap the track covers into the rear of the adjusters.

Fig 1: Installing Track Covers Into Rear Of Adjusters
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
For manual seat adjusters only, install the track cover screw into the rear of the adjusters.
Tighten

Tighten the screw to 2 N.m (18 lb in).

Fig 2: Installing Track Covers Into Front Of Adjusters
Courtesy of GENERAL MOTORS CORP.
Install the track covers into the front of the adjusters.
Install the push-in retainer onto the front track cover.

Fig 3: Installing Push-In Retainer Onto Front Track Cover
Courtesy of GENERAL MOTORS CORP.