LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1265 (Door System, Mirror System & Window System) >> Repair Instructions >> Door Locking Rod/Bellcrank Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door trim panel. Refer to TRIM PANEL REPLACEMENT - SIDE REAR DOOR  .
  2. Remove the rear door water deflector. Refer to WATER DEFLECTOR REPLACEMENT - REAR DOOR  .
  3. Remove the rear inner energy absorber pad. Refer to ENERGY ABSORBER PAD REPLACEMENT - INNER REAR  .
  4. Disconnect the inside locking rod (2) and handle rod (3) from the inside door handle.
  5. Remove the retainer clips from the rods.
  6. Remove the rear door lock. Refer to LOCK REPLACEMENT - REAR DOOR  .
  7. Remove the locking rod from the rear door lock.
    Fig 1: Removing Rear Door Locking Rod From Rear Door Lock
    G01504154Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals