LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 125 (Engine Controls - Removal, Overhaul & Installation - 6.5L Diesel) >> Fuel Systems >> Glow Plug >> Removal & Installation (Bank 2)

Removal & Installation (Bank 2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 GMC C3500 HD, and 2002 Chevrolet RV Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle. Remove the right front tire. Remove the splash shield from the right front wheel well. Remove the lead wires from the glow plug in cylinder No. 2. Remove the lead wires for the glow plugs in cylinders No. 4 and 6 at the harness connectors. Remove the glow plugs from cylinders No. 2, 4 and 6. Disconnect the lead wire at the glow plug from cylinder No. 8 from inside of the vehicle. Remove the glow plug from cylinder No. 8.
  2. Coat the glow plug threads with an Anti-Seize Compound (GM 1052771). Install the glow plug into cylinder No. 8 from inside of the vehicle. Connect the lead wire to the cylinder No. 8 glow plug. Install the glow plugs into cylinders No. 2, 4, and 6 by reaching through the right front wheel well. Install the lead wire to glow plug No. 6. Connect the wires for the glow plugs in cylinders No. 4 and 6 to the connectors at the wire harness. Install the lead wire for the cylinder No. 2 glow plug.
  3. Install the splash shield in the right front wheel well. Inspect the wire routing, ensuring that the lead wires are not rubbing against the exhaust manifold or any part that may harm the wire insulation. Install the right front tire. Tighten fasteners properly. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals