Interior Lighting Modes
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
Perform the following procedure in order to change the interior lighting mode:
- Turn off the instrument panel dimmer switch.
- Turn the ignition switch to the OFF position.
- Remove the MALL PGM fuse.
- Turn the ignition switch to the ACC position.
The BCM sounds the chime a number of times equivalent to the BCM type installed on the vehicle. At this time the BCM has entered the feature customizing mode. In order to change the interior lighting, cycle the IP dimmer switch from the OFF position to the DOME position and then back to the OFF position. The BCM sounds a chime a number of times equal to the lighting mode.
The lighting modes are as follows:
- Mode 1 - Exit illumination and delayed illumination are disabled.
- Mode 2 - Delay illumination is enabled.
- Mode 3 - Exit illumination is enabled.
- Mode 4 - Exit illumination and delayed illumination are enabled.