LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1244 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Inspection >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Important:  Before replacing any engine mount due to suspected fluid loss, verify that the source of the fluid is the engine mount, not the engine or accessories.

  1. Install the J 28467-90A  and the J 28467-B  . Refer to ENGINE SUPPORT FIXTURE  . Raise the engine in order to remove the weight from the engine mount and create slight tension in the rubber.
  2. Observe the engine mount while raising the engine. Replace the engine mount if the engine mount exhibits any of the following conditions:
    • The hard rubber surface is covered with heat check cracks.
    • The rubber is separated from the metal plate of the engine mount.
    • The rubber is split through the center of the engine mount.
  3. If there is movement between the metal plate of the engine mount and its attaching points, lower the engine on the engine mount. Tighten the bolts or nuts attaching the engine mount to the frame or engine mount bracket. Refer to ENGINE MOUNT AND BRACKET REPLACEMENT  .
scientia non olet · About LEMON Manuals