LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1244 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Idler Pulley Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the drive belt idler pulley bracket.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the idler pulley bracket bolts.

    Tighten 

    Tighten the bolts to 30 N.m (22 lb ft).

    Fig 1: Installing Drive Belt Idler Pulley Bracket
    G02083444Courtesy of GENERAL MOTORS CORP.
  3. Install the drive belt idler pulley.
  4. Install the drive belt idler pulley bolt.

    Tighten 

    Tighten the bolt to 50 N.m (37 lb ft).

    Fig 2: Installing Drive Belt Idler Pulley
    G02083445Courtesy of GENERAL MOTORS CORP.
  5. Install the supercharger drive belt. Refer to DRIVE BELT REPLACEMENT (L36)  or DRIVE BELT REPLACEMENT (L67)  .
    Fig 3: Installing Supercharger Drive Belt
    G02083446Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals