LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1244 (Engine Mechanical - 3.8L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Camshaft Removal

Camshaft Removal

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the camshaft thrust plate screws.
  2. Remove the camshaft thrust plate.
    Fig 1: Removing Camshaft Thrust Plate
    G02083791Courtesy of GENERAL MOTORS CORP.
  3. Install one 1/2-20 x 6.0 inch bolt in the camshaft front bolt hole.
    Fig 2: Installing Bolt In Camshaft Front Bolt Hole
    G02083792Courtesy of GENERAL MOTORS CORP.

    Important:  All camshaft journals are the same diameter, so care must be used in removing the camshaft to avoid damage to the bearings.

  4. Carefully rotate and pull the camshaft out of the bearings.
    Fig 3: Rotating And Pull Camshaft Out Of Bearings
    G02083793Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals