LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1243 (Engine Mechanical - 3.1L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Camshaft Rear Bearing Hole Plug Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine flywheel. Refer to ENGINE FLYWHEEL REPLACEMENT  .
  2. Remove the camshaft rear bearing hole plug.
    Fig 1: Removing Camshaft Rear Bearing Hole Plug
    G02081503Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals