LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1243 (Engine Mechanical - 3.1L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Valve Rocker Arm Cover Removal - Right

Valve Rocker Arm Cover Removal - Right

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the electronic ignition control module nuts and bolts.
  2. Remove the electronic ignition control module.
  3. Remove the electronic ignition control module studs.
    Fig 1: Removing Electronic Ignition Control Module
    G02081534Courtesy of GENERAL MOTORS CORP.
  4. Remove the valve rocker arm cover bolts.

    Important:  When removing the valve rocker arm cover make sure the gasket stays in place attached to the cylinder head.

  5. Remove the valve rocker arm cover.
  6. Cut the RTV in the channel where the intake, cylinder head and valve rocker arm cover meet with a suitable tool.
  7. Remove the valve rocker arm cover gasket.
    Fig 2: Removing Valve Rocker Arm Cover
    G02081535Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals