Torque Specifications: 4.3L
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS (4.3L)
| Component | Ft. Lbs. (N.m) | ||
|---|---|---|---|
| Air Cleaner Assembly Bolt | 13 (18) | ||
| AIR Hose Assembly Mounting Bolt | 18 (25) | ||
| AIR Hose Assembly Retainer Bolt | 30 (40) | ||
| AIR Pump Assembly Hold-Down Block Bolt | 18 (25) | ||
| AIR Pump Assembly Mounting Bolt | 18 (25) | ||
| Air Shield Mounting Bolt | 24 (33) | ||
| Distributor Mounting Clamp Bolt | 18 (25) | ||
| Distributor Rotor-To-Reluctor Wheel Screw | 14 (19.5) | ||
| EGR Pipe-To-Intake Manifold Fittings | (1) | ||
| EGR Retaining Fastener-To-Pipe Bracket | 18 (25) | ||
| EGR Valve Attaching Bolt | 18 (25) | ||
| Engine Coolant Temperature (ECT) Sensor | 15 (20) | ||
| Exhaust Gas Recirculation (EGR) Pipe-To-Exhaust Manifold Fitting | 22 (30) | ||
| Fuel & EVAP Pipe Retainer Nut | 21 (28) | ||
| Fuel Pipe Attaching Nut | 20 (27) | ||
| Fuel Pipe Fitting | 20 (27) | ||
| Fuel Pipe Retainer Clip Nut | 21 (28) | ||
| Fuel Tank Strap Attaching Bolt | 15 (20) | ||
| Heated Oxygen Sensor (HO2S) | 31 (42) | ||
| Knock Sensor (KS) Bolt | 18 (25) | ||
| Spark Plugs - Used Heads | 11 (15) | ||
| Spark Plugs - New Aluminum Heads | 15 (20) | ||
| Spark Plugs - New Iron Heads | 22 (30) | ||
| Steering Linkage Shield Mounting Bolt | 24 (33) | ||
| INCH Lbs. (N.m) | |||
| Accelerator Control Cable Bracket Fastener | 106 (12) | ||
| Accelerator Pedal Assembly Mounting Bolt | 44 (5) | ||
| Air Cleaner Outlet Duct Nut | 18 (2) | ||
| Air Cleaner Outlet Resonator Adapter Stud | 71 (8) | ||
| AIR Hose Retainer Clip Locknut | 89 (10) | ||
| AIR Solenoid Mounting Bracket Fastener | 35 (4) | ||
| Camshaft Position Sensor Screw | 20 (2.2) | ||
| Crankshaft Position Sensor Mounting Bolt | 71 (8) | ||
| Distributor Cap Screw | 21 (2.4) | ||
| Distributor Rotor Retaining Screw | 18 (2) | ||
| Evaporative (EVAP) Emission Canister Bracket Bolt | 106 (12) | ||
| Fuel Fill Hose Clamp | 24 (2.8) | ||
| Fuel Injector Retainer Locknut | 27 (3) | ||
| Fuel Pipe Bracket Retaining Bolt | 53 (6) | ||
| Fuel Pipe Retainer Nut | 27 (3) | ||
| Fuel Pipe Retaining Clips Bolt | 106 (12) | ||
| Idle Air Control (IAC) Valve Attaching Fastener | 27 (3) | ||
| Ignition Coil Mounting Screw | 11 (97) | ||
| Ignition Control Module (ICM) Mounting Screw | 31 (3.5) | ||
| Mass Air Flow (MAF) Sensor Clamp | 35 (4) | ||
| Powertrain Control Module (PCM) Connector End Fastener | 71 (8) | ||
| Purge Valve Mounting Nut | 106 (12) | ||
| Throttle Body Assembly Retaining Stud | 80 (9) | ||
| Throttle Position (TP) Sensor Fastener | 18 (2) | ||
| Upper Manifold Bolt | 71 (8) | ||
| Upper Manifold Nut | 71 (8) | ||
| Vacuum Module Attaching Bolt | 71 (8) | ||
|
|||