LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Engine Controls - Removal, Overhaul & Installation - Gasoline) >> Fuel Systems >> Fuel Level Sensor >> Removal & Installation

Removal & Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Relieve the fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE . Drain the fuel tank. Remove the fuel tank. See FUEL TANK .
  2. Remove the fuel sender assembly. See FUEL SENDER ASSEMBLY . Disconnect the fuel pump electrical connector. Remove the electrical connector retaining clip from the fuel level sensor. Disconnect the electrical connector from the fuel level sensor under the fuel sender cover. Remove the retaining clip from the fuel level sensor. Squeeze the locking tangs and remove the fuel level sensor.
  3. To install, reverse removal procedure. Turn ON the ignition for 2 seconds. Turn OFF the ignition for 10 seconds. Turn ON the ignition. Inspect for fuel leaks.
scientia non olet · About LEMON Manuals