LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Engine Controls - Removal, Overhaul & Installation - Gasoline) >> Engine Sensors & Switches >> Throttle Position Sensor >> Removal & Installation

Removal & Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Remove the engine cover. See ENGINE COVER . Remove the throttle position (TP) sensor harness connector. Remove the TP sensor attaching fasteners. Remove the TP sensor from the throttle body assembly. With the throttle valve closed, install the TP sensor on the throttle shaft. Rotate the TP sensor counterclockwise in order to align the mounting holes. Install the TP sensor attaching fasteners. Install the TP sensor harness connector. Install the engine cover.

scientia non olet · About LEMON Manuals