LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Engine Controls - Removal, Overhaul & Installation - Gasoline) >> Engine Sensors & Switches >> Manifold Absolute Pressure Sensor >> Removal & Installation (8.1L)

Removal & Installation (8.1L)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine cover. Disconnect the Manifold Absolute Pressure (MAP) sensor electrical connector. See Fig 1. Remove the MAP sensor retaining bolt and washer. Remove the MAP sensor from the intake manifold. Inspect the MAP sensor seal for wear or damage and replace as necessary.
  2. Lightly coat the MAP sensor seal with Rubber Lubricant (9985770) before installing the sensor. The lubricant should be applied with a sponge or a brush. To prevent blockage, avoid dipping the sensor port directly into the lubricant.
  3. Install the MAP sensor. Install the MAP sensor retaining bolt and washer. Connect the MAP sensor electrical connector. Install the engine cover.
Fig 1: Locating Crankshaft Position Sensor, Manifold Absolute Pressure Sensor & EGR Valve (8.1L)
G00028342Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals