LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Engine Controls - Removal, Overhaul & Installation - Gasoline) >> Emission Systems & Sub-Systems >> Exhaust Gas RECIRCULATION System >> Removal & Installation (EGR Pipe)

Removal & Installation (EGR Pipe)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine cover. See ENGINE COVER . Remove the retaining fastener from the EGR pipe bracket. Loosen the pipe fittings at both ends of the EGR pipe. Remove the EGR pipe.
  2. Install the EGR pipe in the proper location and start the pipe fittings by hand. Ensure that the EGR pipe fittings are correctly lined up on the adaptors to the exhaust and the intake manifolds. Tighten the EGR pipe fittings to the intake manifold and the exhaust manifold. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals