Assembly Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Install the flow control spring (2) to the hydraulic pump housing assembly (1).
Install the control valve assembly (3).
Lubricate the O-ring seal (4) with power steering fluid.
Install the O-ring seal (4) onto the O-ring union fitting (5).
NOTE: Refer to FASTENER NOTICE .
Install the O-ring union fitting (5) into the hydraulic pump housing assembly (1).
Tighten
1. Tighten the fitting (5) to 75 N.m (55 lb ft).
  
  Fig 1: Power Steering Pump Flow Control Valve - Off Vehicle (CB Series)
  Courtesy of GENERAL MOTORS CORP.