Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Sonoma and 2002 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Refer to LIFTING & JACKING THE VEHICLE in General Information.
Remove the nut holding the rear engine mount to the transmission support.

Fig 1: Removing Rear Engine Mount-To-Transmission Support Nut
Courtesy of GENERAL MOTORS CORP.
Remove the mount to transmission bolts.

Fig 2: Removing Mount-To-Transmission Bolts
Courtesy of GENERAL MOTORS CORP.
Raise the transmission using a suitable transmission jack, just enough in order to permit the removal of the mount.
Remove the mount.

Fig 3: Removing Transmission Mount
Courtesy of GENERAL MOTORS CORP.