LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1229 (Manual Transmission - NV 1500) >> Repair Instructions >> Transmission Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sonoma and 2002 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the mount.
    Fig 1: Installing Transmission Mount
    G01840438Courtesy of GENERAL MOTORS CORP.
  2. Install the mount to transmission bolts.

    Tighten 

    Tighten the transmission mount to transmission bolt to 50 N.m (37 lb ft).

    Fig 2: Installing Mount-To-Transmission Bolts
    G01840439Courtesy of GENERAL MOTORS CORP.
  3. Lower the transmission.
  4. Install the nut holding the rear engine mount to the transmission support.

    Tighten 

    Tighten the nut to 45 N.m (33 lb ft).

    Fig 3: Installing Rear Engine Mount-To-Transmission Support Nut
    G01840440Courtesy of GENERAL MOTORS CORP.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals