LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1220 (Engine Mechanical - 3.1L (On-Vehicle)) >> Repair Instructions >> Camshaft Rear Bearing Hole Plug Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine flywheel. Refer to Engine Flywheel Replacement .
  2. Remove the camshaft rear bearing hole plug.
    Fig 1: Camshaft Rear Bearing Hole Plug
    G01702723Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals