Removal & Installation (2.2L - VIN F)
WARNING: This page is about a different car, the 2002 Pontiac Sunfire and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE (GASOLINE) . Disconnect negative battery cable. Remove air intake ducts. Disconnect and mark harness connections and vacuum hoses from throttle body.
- Disconnect the accelerator and cruise control cables from the throttle body and the accelerator bracket. See Figure. Remove the 2 accelerator bracket nuts. Remove the accelerator bracket from the throttle body.
- Remove the throttle body attaching bolts and studs. Remove the throttle body and gasket from the intake manifold.
- Inspect the throttle body gasket and replace if necessary. Install the throttle body to the intake manifold. Tighten the throttle body attaching bolts and studs, and accelerator cable bracket nuts to specification. See TORQUE SPECIFICATIONS . Test the accelerator movement by depressing the pedal to the floor and releasing the pedal.