LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 122 (Engine Controls Removal & Installation) >> Fuel Systems (CNG Engine) >> Fuel Gauge Select Switch >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2002 Pontiac Sunfire and 2002 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable SIR system. See appropriate AIR BAG RESTRAINT SYSTEMS article in ACCESSORIES & EQUIPMENT. Remove Instrument Panel (IP) trim pad. Remove defroster grille screw. Using a flat-bladed tool, remove defroster grille from IP trim pad. Remove IP outer trim cover screws. Remove IP outer trim covers. Open glove compartment and remove right IP trim plate bezel. Remove IP trim pad screws and remove IP trim pad from IP carrier.
  2. Remove screws from IP trim plate and remove IP accessory trim plate by pulling rearward to disengage retainers. Disconnect electrical connectors from trim plate. Unsnap fuel gauge select switch from trim plate. To install, reverse removal procedure.