LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1219 (Engine Mechanical - 4.2L 6-Cylinder (Unit Repair)) >> Repair Instructions >> Thermostat Housing Installation

Thermostat Housing Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the thermostat housing.
  2. Install the thermostat housing bolts.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

    Tighten 

    Tighten the thermostat housing bolts to 10 N.m (89 lb in).

    3. Fig 1: Installing Thermostat Housing Bolts
    G01706727Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals