Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Install the outer tie rod assembly (3) to the inner tie rod assembly (1). Do NOT tighten the jam nut (2).

Fig 1: Installing Outer Tie Rod Assembly To Inner Tie Rod Assembly
Courtesy of GENERAL MOTORS CORP.
Install the outer tie rod assembly (2) to the steering knuckle (1).

Fig 2: Installing Outer Tie Rod Assembly To Steering Knuckle
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE .
Install the prevailing torque nut (2) to the outer tie rod assembly (1).
Tighten

Tighten the nut to 30 N.m (22 lb ft) + 115 degrees of rotation.

Fig 3: Installing Torque Nut To Outer Tie Rod Assembly
Courtesy of GENERAL MOTORS CORP.
Tighten the jam nut (2) against the outer tie rod assembly (3).
Tighten

Tighten the jam nut to 68 N.m (50 lb ft).
Install tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
Lower the vehicle.
Perform a front end alignment. Refer to MEASURING WHEEL ALIGNMENT .

Fig 4: Tightening Jam Nut Against Outer Tie Rod Assembly
Courtesy of GENERAL MOTORS CORP.