LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1214 (Body Rear End) >> Repair Instructions >> Latch Striker Replacement - Rear Lift Window Panel >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the striker to the lift window panel with the short end of the striker facing forward.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the bolts attaching the striker.

    Tighten 

    Tighten the lift window latch striker bolts to 10 N.m (89 lb in).

  3. Close the lift window.
    Fig 1: Removing Bolts Attaching Striker
    G01452070Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals