LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1214 (Body Rear End) >> Repair Instructions >> Latch Replacement - Rear Compartment Lid >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the bolts attaching the latch to the latch bracket.

    Tighten 

    Tighten the rear compartment lid latch bolts to 10 N.m (89 lb in).

  2. Route the manual release cable down to the rear center floor stowage compartment.
  3. Install the rear center carpet panel.
    Fig 1: Rear Compartment Lid Latch
    G01452054Courtesy of GENERAL MOTORS CORP.