LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1213 (Interior Trim) >> Repair Instructions >> Trim Replacement - Lock Pillar (Lower Convertible and Hard Top) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the sill plate. Refer to DOOR SILL PLATE REPLACEMENT  . 
  2. Pull the lock pillar trim panel with retainers from the lock pillar and the side rail.
    Fig 1: Pulling Lock Pillar Trim Panel With Retainers From Lock Pillar & Side Rail
    G01451775Courtesy of GENERAL MOTORS CORP.
  3. Slide the lower lock pillar trim out from under the upper lock pillar trim panel (convertible), rear side panel (hard top).
  4. Separate the trim panel from the seat belt.
  5. Remove the lock pillar trim.
    Fig 2: Sliding Lower Lock Pillar Trim Out From Under Upper Lock Pillar Trim Panel
    G01451776Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals