LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1213 (Interior Trim) >> Repair Instructions >> Trim Replacement - Lock Pillar (Lower Convertible and Hard Top) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Route the seat belt through the lock pillar trim panel.
  2. Position the lower lock pillar trim panel under the upper lock pillar trim panel (convertible), side trim panel (hard top).
  3. Install the foam insulator behind the lock pillar trim.
  4. Position the lock pillar trim panel retainers to the holes in the lock pillar and the side rail.
    Fig 1: Positioning Lower Lock Pillar Trim Panel Under Upper Lock Pillar Trim Panel
    G01451777Courtesy of GENERAL MOTORS CORP.
  5. Push in on the panel securing the retainers.
  6. Install the sill plate. Refer to DOOR SILL PLATE REPLACEMENT  . 
    Fig 2: Pushing Lock Pillar Trim Panel With Retainers Into Lock Pillar & Side Rail
    G01451778Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals