LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1213 (Interior Trim) >> Repair Instructions >> Trim Panel Replacement - Rear Roof Bow >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the roof bow interior trim panel to the roof bow attaching the left center alignment clip first.
  2. Align the rear antenna cable to the notch in the rear flange of the trim panel.
  3. Push upward on the trim panel attaching the remaining clips and the hook and loop fastener patches.
  4. Install the push-pins through the ends of the roof bow center trim panel.
  5. Install the roof lift off panel.
    Fig 1: Roof Lift Off Panel
    G01451914Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals