Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Apply sealer GM P/N 12345739 (Canadian P/N 10953472), or equivalent to the forward end of the front side weatherstrip retainer (1).

Fig 1: Applying Sealer To Forward End Of Front Side Weatherstrip Retainer
Courtesy of GENERAL MOTORS CORP.
Apply a bead of sealer GM P/N 12345739 (Canadian P/N 10953472), or equivalent 6 mm (2.4 in) high around the front side retainer (1) in the following places:
- At the front upper corner (3)
- On both sides (2)
Fig 2: Applying Bead Of Sealer Around Front Side Retainer
Courtesy of GENERAL MOTORS CORP.
Apply a drop of sealer GM P/N 12345739 (Canadian P/N 10953472), or equivalent (3) 12 mm (0.5 in) in diameter to the screw heads of the center side retainer.
Remove the protective film from the adhesive on the weatherstrip.

Fig 3: Protective Film From Adhesive On Weatherstrip
Courtesy of GENERAL MOTORS CORP.
Install the side rail weatherstrip, as necessary.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the screw to the front side rail weatherstrip.
Tighten

Tighten the screw to 4 N.m (35 lb in).
Reposition the top to the original position.

Fig 4: Screw To Front Side Rail Weatherstrip
Courtesy of GENERAL MOTORS CORP.